Hello Shyam, The Port 2 input register also needs to be set. This reminds me to tell you that when you make a shift in your data you must make sure that the sign of the data carries as well. Due to the holidays, responses may be delayed. I purchased a Windows laptop and replaced Windows with Ubuntu Rajesh, Could you please share a complete schematic of this design? Hello, I would like to kindly ask you if you could help me to get any driver for linux kernel ideally 3.

Uploader: Moogutaur
Date Added: 24 October 2014
File Size: 42.97 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40218
Price: Free* [*Free Regsitration Required]

Now I restored the system defaults, but how to achieve the “Realtek High definition audio” quality in the end? Content on this site may contain or be subject to specific guidelines or limitations on use.

Ask a related question Ask a new question. Couldn’t find any package linyx glob ‘linux-restricted-modules Thank you Hack-R, I had your very same problem on Kubuntu Trademarks Privacy Policy Terms of Use. The newly created question will be automatically linked to this question. You only need 10us after power up for a delay.


Articles on this Page showing articles to of Done Building lnux tree Reading state information Feb 6, 2: By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. Hello Shyam, The Port 2 input register also needs to be set.

Shyam, Register 0x42 controls the mux that feeds the Port 1 TX pin.

i.MX6 SSI ALSA simultaneous Capture and Playback not working for mono streams

Browsing All Articles Articles. Check out our Code of Conduct.

I think the most difficult part of this Linux driver is the register settings. Does the triggering on J3 also work for DAC to serve our purpose? Other than that it is difficult to say what might be going on.

Data converters

Linux driver for LM In reply to Andy Liu SH:. Correct om49350 of I’m wrong. What are the applications requirements? In reply to Shyam Krishnan: We are glad that we were able to resolve this issue, and will now proceed to close this thread.

Is this capture a single code-to-code transition or are you applying a ramp i. As I don’t want to share entire schematic here. I tried with the solution from https: It did not go well:. How is the V PWM signal being generated?


– Restore default audio drivers in Ubuntu 16 – Ask Ubuntu

I have set the basic settings registers 0x50 and 0x60 as 0x1f. Some questions about the DAC data file. In reply to Nicolai Heilemann:. The result is “right shifted” by 6 bits assuming the 6 lower lm43950 as noise As you can see, the converter starts to output a constant value 15 despite the signal coming from the load-cell. Browse the Latest Snapshot.

TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for lm493550 particular purpose, title and non-infringement of any third party intellectual property right.